09mm absolute encoder
Specifications:
| Mechanical characteristics | ||
| Items | Specifications | Condition |
| Rotational torque (gf. cm) | 250~500gf.cm | |
| Push-pull strength | Push/Pull 10Kgf | 10Kgf.cm for 15 seconds |
| Total rotational angle | 337.5 ° | |
| Number of detent | 16 | Rotate a week (337.5 °) positioning number |
| Electrical characteristics | ||
| Items | Specifications | Condition |
| Contact rating | 0.15AMP at 30V.D.C resistive | |
| Contact resistance |
Contact resistance (ON) 200mΩmax Contact resistance (OFF): 1MΩmin (before reflow test and cycle test) |
After being rotated several times,measured by voltage decreasing method at 5V DC 1A of less than 2mv 1k HZ |
| Insulation resistance | 100MΩ以上 100MΩMIN | At DC 250V |
| Dielectric strength | No subversion on insulating material | AC300V(50~60HZ) 1 minute |
| Output signal | Refer to attached drawing | |
| stopper strength | 5Kgf.cm |
|
| Durability | ||
| Items | Specifications | Condition |
| Rotational life |
Contact resistance (ON) : 1Ωmax, (OFF): 1MΩmin Detent torque：150gf.cm min |
Encoder shall be operated 10,000 cycles at 720 cycles /H ( without load ) . |
| Operating temperature | -40℃~+85℃ | |
Note: If the description of the same with the recognition of the specification parameters, the picture is different, have admitted that the book shall prevail.
Outline
Copyright 2017 Dongguan Changtaier Electronic Co., Ltd. All Rights Reserved. 粤ICP备05100315号 Powered by www.300.cn